End-Load Rail Carts

End-Load Rail Cart

Hytracker End-Load Rail Cart

EXCAVATORS ON END-LOAD RAIL CARTS ARE USED FOR THE FOLLOWING PROJECTS:

• Culvert installation & maintenance
• Ditch cleaning
• Under-cut mud spots
• Rip rap projects
• Response to slides and washouts
• Derailment clean up
• Tunnel maintenance
• Place lock block walls
• Brush cutting
• Material handling with magnet

* End-Load Rail Carts can pull or push 25 Yard Ditching Gondolas or Tow Carts for moving material and equipment around.

ALL HYTRACKER END-LOADS

Stabilizer options: (box beam stabilizers look the same as on Side-Load Rail Carts) You can get all under deck stabilizers which come down on the ties, they are good for bridge work, tight areas. You can get a box beam on the drive end and under deck on the ramp end. All stabilizers have HD counter balance value which allows you to have the stability to work from the cart.

END-LOAD RAIL CART SPECIFICATIONS

• 60,000 lbs capacity
  • Suitable for 20 Metric Ton Class of excavators
  • Flat Deck Design
  • Pintle hitch
  • Air on both ends
  • 9’ 6” Wide Deck
• 95,000 lbs capacity
  • Suitable for 30 Metric Ton Class of excavators
  • Option of Flat Deck or Cantilever — where the center of the Cart is higher and the excavator sits a bit lower than a Flat Deck style
  • Knuckle box on drive end
  • Pintle hitch on ramp end
  • Air on both ends for trailer air brakes
  • 8” swing outs on each side of 9’ 6” Deck

End-Load Rail Cart Photo Gallery — April 15, 2016

325 Cat on End-Load Rail Cart